Slurry Slaker

Chemco slurry slakers produce quality hydrated lime from commercial grade quicklime.

 

Slakers are used to convert Calcium Oxide to Calcium Hydroxide for use in neutralization and pH control.

Typical Slaking Process

Quicklime and water are fed to the slaker at a proper ratio.  Hydration process takes place under vigorous agitation.  Hydration process is an exothermic reaction; therefore, a great deal of heat is released during the hydration process.

 

The resultant hydrated lime exits the reaction chamber into the grit separation chamber where grit is removed from the slurry and slurry is discharged into a storage tank.

Special Features of Chemco Slurry Slakers
  • Modulating water fed to maintain constant slaking temperature
  • Slurry consistency control to prevent slurry getting too thick
  • Over temperature alarm and cooling system
  • Integral heat exchanger to heat incoming slaking water
  • Replaceable wear plate on the inside
  • Dual-wall insulated body
  • Safety latches with proximity switches on all access panels
  • Integral grit separation system
  • Optional vibrating grit separation screen
  • Minimum retention time of 10 minutes at 100% feed rate
  • Available sizes from 250 PPH to 50,000 PPH
Photos

 

 

 

 Click Here for larger image

 Click Here for larger image

 Cilck Here for larger image